Thinking about adding a skylight? The biggest concern is always leaks. Here's why ours don't leak: we build a structural curb between the rafters, wrap it in ice-and-water shield, install step flashing on all four sides, and re-shingle around the unit with proper overlap. Then we verify the seal from inside the attic. Fort Covington Roofing & Maintenance — leak-free skylight installation in Fort Covington.
We install deck-mounted skylights and curb-mounted skylights. Deck-mounted units sit flush against the roof deck and work best for shingle roofs on standard pitch. Curb-mounted units sit on a raised frame and work on flat or low-slope roofs. Both types get the same flashing treatment: ice-and-water shield, step flashing, counter-flashing, and sealant at every transition.
Our Skylight Installation Process
Skylight Planning
Free on-site assessment. We check your roof structure, identify the optimal position between rafters, and present skylight options with honest pricing. Sun angle analysis included.
Roof Opening & Framing
Precise opening cut through the roof deck. Structural curb framed between trusses with load-bearing headers. Every cut edge of the sheathing sealed. The curb is the structural foundation — we don't skimp on the framing.
Flashing & Waterproofing
Full flashing system: ice-and-water shield base layer, step flashing and counter-flashing on all four sides, woven into the existing shingle field. Water flows over the flashing and onto the shingles below — never behind them.
Completion
Skylight unit set into the curb and flange sealed to the roof deck. Shingles re-laid around the unit with proper overlap. Inside, rigid insulation installed around the light shaft to prevent condensation. Interior trim finished. Watertight verified from the attic.
What Fort Covington Customers Say
"From the first phone call to the final walkthrough, everything was seamless. The team was courteous and efficient. Already recommended them to two friends."
"After getting several quotes, these guys stood out with their honesty and knowledge. No pressure, just straightforward advice and excellent workmanship."
"Responded fast and got the job done right the first time. Crew was polite, professional, and cleaned up everything. Would absolutely hire again."
Why Choose Fort Covington Roofing & Maintenance for Skylight Installation?
Insulated Light Shafts
Every skylight installation includes rigid foam insulation around the light shaft. Uninsulated shafts cause condensation and energy loss. We insulate, vapor-seal, and trim the interior for a finished look.
Code Compliant
Every skylight installation meets NY building code for structural framing, energy performance, and egress requirements. Permits pulled when required.
Structural Curb Framing
We frame a proper structural curb between your rafters with doubled headers. No flimsy brackets or foam shims. The curb carries the skylight load and provides a solid base for the flashing system.
Leak-Free Guarantee
Every skylight gets ice-and-water shield, step flashing on all four sides, counter-flashing, and sealant at every transition. Verified from inside the attic before we leave. If it leaks, we fix it free.